Inside Of The Enforcer 32-We: Rear; Inside Of The Enforcer 32-We: Front - Pyronix Enforcer 32-WE Programming And Installation Manual

Enforcer Programming Manual

6.2 Inside of the Enforcer 32-WE: Rear

1. Terminals for Earth and Mains Supply. See page:
35.
2. If a modem is required (The DIGI-1200 or DIGI-
GSM) then this space is used to install them. See
page: 43.
3. The transformer is situated in a housing, this
shouldn't need to be removed.
4. The rear tamper adjustment screw is used if the
tamper from the front of the Enforcer 32-WE isn't
sitting flush to the back plate - this may happen if
the Enforcer 32-WE is installed on an uneven
surface.
5. If an I/O board is installed, then this space is
used to install it. See page: 39.

6.3 Inside of the Enforcer 32-WE: Front

1. RS232 connection for Up/downloading to
the InSite software. See page: 38.
2. Where the control panel battery is located.
See page: 37.
3. The power connection for a Digi-GSM if
connected. See page: 43.
4. The connection for an I/O board if
connected. See page: 39.
5: The connection for the modem installed
(Digi-GSM or Digi-1200). See page: 43.
6: The power connection (+12V DC) for the
Enforcer 32-WE.
Page: 36