Sartorius Combics Series Operating Instructions Manual page 75

Operation
( (
Digital Input/Output Interface The Checkweighing application supports the digital input/output-interface.
74 Operating Instructions Combics Indicators
CTRL.SET Activate SET control output
OUTP.ACT Activation of outputs
INPUT Parameter input
AUT.PRNT Automatic printing
APP.ZERO Checkweighing toward zero
)
t T o save the setting, press the ) key.
... t T o exit setup: Press the ( key several times.
Display The result of a measurement is shown either as a weight value or in relation to the
target.
Weight display: The measured value line always shows the weight value, even if it
lies outside the tolerance range. The bar graph is displayed with symbols indicating
lower limit, target and upper limit. Weights are shown logarithmically up to the
lower tolerance limit, and linearly beyond that point.
Relation to target value: As "Weight display" above, with the exception that:
– L L appears in the main display if the weight value is less than the lower limit
– H H is shown on the main display if the weight value is higher than the upper
limit
The four outputs are activated as follows:
– Lighter > red LED lights
– Equal > green LED lights
– Heavier > yellow LED lights
– Set
The outputs can also be galvanically isolated using option A5.
Acoustic signal: An acoustic signal can be activated in addition to the green LED.
Setting: menu item 8.2.3
SET output
OUTPUT
Ready to operate
OP.READY
Off
OFF
Always on
ALWAY.ON
At stability
STABIL.
Within checkweighing range
CHECK.RG
O n at stability within
STAB.CHK
checkweighing range
Min, Max, target value
TAR.MN.MX
Only target value with percent limits
TARG.PER
T arget value with asymmetrical
TAR.A.PER
percent limits
Target value with relative tolerances
TAR.TOL
Off
OFF
On
ON
Only values within tolerance
OK
Only values outside tolerance
NOT OK
Off
OFF
On
ON
4.3.
4.3.1*
4.3.2
4.4.
4.4.1
4.4.2
4.4.3
4.4.4*
4.4.5
4.5.
4.5.1*
4.5.2
4.5.3
4.5.4
4.6.
4.6.1*
4.6.2
4.6.3
4.6.4
4.7.
4.7.1*
4.7.2