Sartorius Combics Series Operating Instructions Manual page 35

Operating Design
Display in Weighing Mode
34 Operating Instructions Combics Indicators
The Display
There are two display modes:
– Display for weighing (weighing values and calculated values)
– Display in "Menu mode" (device settings)
The figure shows the display of the Combics 2
20
19
18
Appl. 1
1* Bar graph showing 10% intervals
– S hows the percentage of the weighing platform's capacity that is "used
up" by the load on the scale (0% = lower limit, 100% = upper limit)
or
– S hows the measured value in relation to a target value (with the
"Checkweighing" or "Classification" applications)
Minimum for checkweighing
Maximum for checkweighing
Target value for checkweighing
S
2
Symbol for active print job
3 R8 Displays the active range on multiple-range scales
4
I ndicates active weighing platform; flashes to prompt calibration/
adjustment
5* 1 2
Selected weighing platform 1 or 2
6 NET B/G N et/Gross value on the main display (with tare in memory or preset tare)
k
7
I dentifies the value on the main display as calculated (value not valid in
legal metrology)
8
Battery charge status
9
GMP-compliant printing in progress
p
10
Weight unit of the value displayed
11*
Numeric display; e.g., showing the reference value
12*
S ymbol indicating data transfer
– Interface initialized (profibus/Ethernet)
– F lashes during data transfer (RS-232/485)
13* Mem
Symbol for product data memory
14
I n legal metrology, on equipment with e not equal to d, the digit
bordered for identification is not taken into account
15* AUTO/OPT
AUTO: D epending on the weight value, a reaction is triggered in the
–
application
OPT: A utomatic optimization takes place for the Counting application
–
16
Measured value line: Weight value or calculated value
* = for Combics 2 only
1
Appl. 2 Appl. 3
16 15
17
3
2 4 5
14 13 12 11
6
7
8
9
10