Mode Selection Registers; Rising Edge Detection Select Register Bit Assignment; Falling Edge Detection Select Register Bit Assignment; Change Detection Enable Register Bit Assignment - Toshiba V Series User Manual

Chapter 2 General Specifications
2
78

(2) Mode selection registers

These registers are accessed by the special module data write instruction (WRITE
instruction in S2T, MWRITE instruction in S2)
Address
0 Rising edge detection select register
1 Falling edge detection select register
2 Change detection enable register

[Rising edge detection select register bit assignment]

Bit F E D
UE UE UE UE UE UE UE UE UE UE UE UE UE UE UE UE
UE: When '1', the interrupt is generated at the time of corresponding input is changed OFF
to ON. (iInitial value is all '1')

[Falling edge detection select register bit assignment]

Bit F E D
LE LE LE

[Change detection enable register bit assignment]

Bit F E D
- - -
DE: When '1', change detection is enabled.
When '0', change detection is disabled and change detection status is cleared. (Initial value
is '1')
[Caution]
I/O interrupt is not generated when the bit DE is '0'.
After power on initializing, the change detection mode of all bits is set only rising edge
detection is enabled.
In order to change the mode of change detection, write data in the mode register by the
special module data write instruction (WRITE instruction in S2T, MWRITE instruction in S2)
in the user program.
Refer to the instruction manual for details of the special module data write instruction.
Description
C B A 9 8 7
C B A 9 8 7
LE LE LE LE LE LE
C B A 9 8 7
- - - - - -
model 2000 Sequence Controller S2 User's Manual -Basic Hardware-
6 5 4 3 2 1
6 5 4 3 2 1
LE LE LE LE LE LE
6 5 4 3 2 1
- - - - - -
0
0
LE
0
DE