Kinematic Transformation; Signals From Channel (Db21 - Siemens SINUMERIK 840D sl Function Manual

NC/PLC interface signals (Z2)

19.7 Kinematic transformation

19.7 Kinematic transformation
19.7.1

Signals from channel (DB21, ...)

DB21, ...
DBX33.6 Transformation active
Edge evaluation: No
Signal state 1 or The NC command TRANSMIT, TRACYL, TRAANG or TRAORI is programmed in the part program.
edge change 0 → 1 The corresponding block has been processed by the NC and a transformation is now active.
Signal state 0 or No transformation active.
edge change 1 → 0
References /PGA/ Programming Guide, Advanced
/FB3/ Function Manual, Special Functions; 3- to 5-Axis Transformation (F2).
1050
Signal(s) updated: Cyclic
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Extended Functions