Configure The Printer In Psf/Mvs - Xerox DocuColor 2060 Installation Planning Manual

Table F-5. PSF/MVS PRINTDEV statement parameters
Item
description Default
APPLID None
BUFNO
FAILURE
FDEFDD None
FONTDD None
Installation Planning Guide
Defining the printer to the host: TCP/IP attachment

4. Configure the printer in PSF/MVS

Follow these steps to configure the printer in PSF:
1. Locate the PSF startup procedure in the JES3 or JES2
startup JCL procedure. This is normally kept in
SYS1.PROCLIB, although your system may use a different
library.
The libraries specified by the //PROC00 DD statement
normally contains startup procedures for PSF subsystems.
The name of the procedure is specified in the initialization
dataset (FSS statement PROC parameter in JES2; the
FSSDEF statement PNAME parameter in JES3. See the
appropriate section in this appendix for clarification).
2. Add a PRINTDEV statement to define the printer in PSF.
(See the example below for the general format or the Print
Services Facility for OS/390 Customization for more
information.)
The table below contains descriptions of the PSF parameters
which need to be set for the printer.
Range of
Source of acceptable
value values
VTAM APPL 1 to 8-character
statement alphanumeric
string
N/A 5 to 100
Installation WCONNECT or
preferences STOP
Installation 1 to 8-character
preferences alphanumeric
string
Installation 1 to 8-character
preferences alphanumeric
string
Comments
Not applicable for TCP/
IP-attached printer
Not applicable for TCP/
IP-attached printer
If printer is used by other
hosts, WCONNECT
causes PSF to
continuously retry to
establish connection with
printer.
Name of the form
definition library DD
statement
Name of font library DD
statement. Fonts in this
library must match
resolution the printer is
using.
Your
value
F-9