3.3
Communication Parameter Setup
(Print Services on Web)
The communication parameters for TCP/IP, Serial, Centronics (optional), VPI
(optional), and SNMP can be set up from Print Services on Web. These procedures are
explained below.
Procedure
1
• The machine must be rebooted for the changes to take effect.
• These procedures are performed in the Administrator Mode.
Start Print Services on Web, enter the Administrator mode, and select the
[Properties] tab.
Refer to "2.3 Print Services on Web" for details about starting Print Services
on Web and logging on as Administrator.
The displayed [Print settings] were set up earlier using the selections on the
[Print Setup] and the [Properties] tabs. The hardware configuration
information is stored in the machine's controller.