Actual Load Calibration - Unipulse F320 Operation Manual

5-2. Actual Load Calibration

The actual load calibration uses the following procedure
Releasing Calibration LOCK
Setting Decimal Place
Setting Scale Division
Zero Calibration
Actual Load Calibration
Calibration LOCK
Release the calibration LOCK that inhibits
calibration.
Set the decimal place.
（omissible if no desired value is present）
Set the minimum value of the digital change
desired.
（omissible if no desired value is present.）
Set the zero point of the strain gauge sensor.
Set the span(gain) point of the strain gage
sensor.
Set the calibration of ON to prevent
misoperation.
5.CALIBRATION
36