Setting Procedure - Unipulse F320 Operation Manual

4-4. Setting Procedure

"F1" of setting Mode1
＋ －
FNC
is displayed.
ZERO
"F2" of setting Mode2
is displayed.
GAIN CAL
Select a
setting item.
If one minute has elapsed after
is pressed,the setting is canceled and the indicated value is displayed again. The set value
is not stored in this case.
ZERO
"F3" of setting Mode3
is displayed.
GAIN CAL GAIN
Select a
setting item.
The most significant digit starts blinking
HOLD
to prompt setting.
Select a digit where setting is desired.
ZERO
CAL
GAIN
Set Value is validated.
HOLD
Setting Mode is terminated to return to
＋ －
FNC the indicated value display.
＋ －
key is pressed without any key hit before
FNC
4.SETTING MODE CONFIGURATION
ZERO ZERO
"F4" of setting Mode4
is displayed.
CAL GAIN
Select a
setting item.
Set a value.
If wishing to affix a sign to the high/low limit
igital offset
and d , D/A zero setting full scale
setting, press key.
＋ －
FNC
CAL
Select a
setting item.
key
HOLD
28