11-1-1Obtaining Voltage Output Signal; 11-1-2Setting Of D/A Zero And Gain - Unipulse F320 Operation Manual

11-1-1. Obtaining Voltage Output Signal
Use the + and - terminals of the F320 for connection with an external device
(2kΩ or more load resistance).
← Inside Outside →
• The D/A converter voltage output is an option.
• Do not apply external voltages. Breakage will result.
• Do not short-circuit the voltage output. Doing so will cause a failure.
Also, connecting a capacity load may cause oscillation.
11-1-2. Setting of D/A Zero and Gain
With the D/A converter of the F320, an analog output is obtained by setting the
indicated value to output 0V (D/A zero set value) and the indicated value to
output 10V (D/A full scale set value). Respective set values are inputted by the
D/A zero and full scale setting functions.
F320
SIG
+
-
CAUTION
Voltage
（V）
10
Resolution 1/10000
0
-10
11.D/A CONVERTER
+
External device
-
Load resistance
2kΩ or more
GND
Indicated value
D/A zero set value D/A full scale set value
92