11．D/A Converter; Voltage Output (Dav Option) - Unipulse F320 Operation Manual

11.D/A CONVERTER
11. D/A CONVERTER

11-1. Voltage Output (DAV Option)

This converter is used to obtain an analog output which is linked with the
indicated value of the F320.
The range of the analog output is from -10 to +10V.
An analog output from 0V to ±10V can be obtained with respect to any digital
values set by the D/A zero setting and the D/A full scale setting functions.
The output circuit and the main circuit are isolated.
Voltage output:
D/A conversion speed:
Resolution:
Over range:
Zero adjustment range: Approx. -1.0 to +1.0V (at the time of zero output)
Gain adjustment range: Approx. 9.5 to 10.5V (at the time of full scale output)
Zero drift:
Gain drift:
Non-linearityv
Output connector:
91
Voltage output terminals
Terminals for obtaining voltage signal.
"+" is for signal, and "-" is for ground.
0 to ±10V can be obtained.
+ -
Zero adjustment trimmer
Trimmer to adjust so that the voltage output becomes
zero when the indication is as registered by the D/A
zero setting function.
The zero adjustment range is approx. -1.0 to +1.0V
(at the time of zero output).
-10 to 10V (load resistance; 2kΩ or more)
2000 times/sec.
1/10000
-11.0 to +11.0V
Within 0.6mV/ ℃
Within 50ppm/ ℃
Within 0.05%FS
* Not including the drift of the analog input section
Screw type terminal block (two-pole)
Gain adjustment
trimmer
Trimmer to adjust so
that the indication
becomes as registered
by the D/A full scale
setting function.
The gain adjustment
range is approx. 9.5 to
10.5V (at the time of
full scale output).