Indicator Section; Setting Section - Unipulse F320 Operation Manual

16-2. Indicator Section

Indicator
Items

16-3. Setting Section

Key switch
Items
Numerical display (5-digit),
15mm in character height, by 7-segment red LED
Numeric 5digits ±
("
high order position of the indicator.)
Indicatid value -19999 to 19999
Decimal point The display position is selectable.
88.888, 888.88, 8888.8, 88888
Status HI, OK, LOW, PEAK, HOLD
Red LED 5
Count 3, 6, 13, 25times/sec. Selectable
FNC GAIN CAL
（+/-） （▲） （▼）
Calibration:Zero/Span calibration（actual load calibration,
equivalent input calibration）
<Setting mode 1>
High limit value, Low limit value, High/Low limit comparison
mode, Hysteresis, Digital offset, Near zero
<Setting mode 2>
Digital filter, Analogfilter, Motion detect（time）,
Motion detect（range）, Zero tracking（time）,
Zero tracking（range）,Hold mode
<Setting mode 3>
Set value LOCK, Calibration LOCK, ZERO key valid/invalid,
HOLD key valid/invalid, Scale division, Display frequency,
Decimal place, Excitation voltage
<Setting mode 4>
RS-485 communication method, RS-485 ID,
RS-485 transmission delay time, BCD data update rate,
D/A zero setting, D/A full scale setting , D/A output mode,
Password
16.SPECIFICATIONS
" or nothing is displayed at the
ZERO HOLD
（5key）
（ ） （ ）
110