WorkCentre Pro 665/685/765/785
Confirmation Report Setup
Confirmation Reports can automatically be printed by the WorkCentre
following each transmission, or only following transmissions where an
error occurred. Using the setup procedure you can select which type
of transmissions automatically print a Confirmation Report, and under
which conditions the report is printed:
•
Always — Prints a report after every communication.
•
On Error — Prints a report only when an error occurs.
•
Off
— A report is not automatically printed.
In addition, you can set the WorkCentre to print the first page* of the
fax on the report for Memory Send, Group Send, Relay Originator,
Relay Station, and Relay Destination reports.
Automatic Confirmation Reports are available for the following
operations:
•
Confirmation Report
Send transmission.
•
Confirmation Report
Transmission results.
•
Group Send Report
•
Group Poll Report
•
Relay Originator Report
Transmissions initiated by the Originator Station.
•
Relay Station Report
initiated by the Relay Station.
•
Relay Destination Report
results sent from the Relay Station to the Originator Station, and
printed by the Originator Station.
* Not allowed in all markets.
—
Prints transmission results for a Direct
–
—
Memory Send
—
Prints Group Transmission results.
—
Prints Group Polling Transmission results.
—
Prints results for Relay
—
Prints results for Relay Transmissions
—
Prints Relay Destination Station
Reports
Prints Memory Send
9-5