Programming the Machine
Setting the Machine Default Settings
2-40
Error Correct - ECM Default Setting
Error Correction Mode (ECM) is an internationally-recognized error
correction system. It enables communications with clean images
since it automatically re-sends any portion of the document affected
by line noise or distortion.
This feature cannot be accessed if a document is stored in memory.
Note: ECM must be set to On when the 33.6K BPS Modem is in
your machine.
•
Both the sender and the receiver must have the ECM feature to
perform ECM communications.
•
Communication time is longer when transmissions are affected
by interference.
To set the Error Correct-ECM default mode:
1. Press:
Menu
2. To enable ECM, press
To disable ECM, press
3. The menu selection screen redisplays. Press Exit or Stop to
return to the Standby Mode.
*** Menu item numbers may vary according to configurations.
***
Error correct-ECM
1. On
2. Off
.
.
WorkCentre Pro 665/685/765/785