Tractor Set Assembly; Mounting The Manifold And Hydraulics - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I CAN

2. Tractor set assembly

It is recommended to assemble the tractor set in the
following order:
1. Mount the hydraulic manifold and all hydraulic
hoses.
2. Mount the steering controller to the hydraulic
manifold.
3. Mount the entire wiring harness from the
battery.
4. Mount the wheel angle sensor and cable.
5. Mount the GPS antenna and radio/GSM
antennas and all antenna cables.
6. Mount the DynamIQ ISO.
7. Mount the terminal.
3. Mounting the manifold and
hydraulics
Figure 1 shows a manifold mounted onto a manifold
bracket with four M8 bolts. The manifold bracket is
preferably mounted at the right hand side of the
tractor (Figure 2). This is usually the side of the tractor
with the most space.
Pay attention!:
Make sure the connectors of the valves and the
pressure sensor can still be connected after
mounting the manifold.
Figure 1 Manifold bracket with a manifold and
steering controller mounted.
Figure 2 Mounted manifold and steering controller.
SBG-Auto CAN-EN-Rev. A I Page 15/52