Safety; Symbols; Warnings - MICRO-EPSILON scanCONTROL 29 Series Operating Instructions Manual

Safety

1.
System operation assumes knowledge of the operating instructions.
1.1
The following symbols are used in these operating instructions.
i
Measure
1.2
Connect the power supply and the display-/output device according to the safety regulations for electrical
equipment
> Risk of injury
> Damage to or destruction of the sensor
Avoid shocks and impacts to the sensor.
> Damage to or destruction of the sensor
The supply voltage must not exceed the specified limits.
> Damage to or destruction of the sensor
Avoid continuous exposure to dust and spray on the sensor by appropriate methods such as blowing or us-
ing a protective housing.
> Damage to or destruction of the sensor
Do not touch the protective windows of the optics with the fingers. Wipe off any fingerprints immediately with
pure alcohol and a clean cotton cloth with no streaks.
scanCONTROL 29xx
Safety

Symbols

Indicates a hazardous situation which, if not avoided, may result in minor or mode-
rate injury.
Indicates a situation that may result in property damage if not avoided.
Indicates a user action.
Indicates a tip for users.
Indicates hardware or a software button/menu.

Warnings

Page 7