Liability For Material Defects; Service, Repair; Decommissioning, Disposal - MICRO-EPSILON scanCONTROL 29 Series Operating Instructions Manual

Liability for Material Defects

9.
All components of the device have been checked and tested for functionality at the factory. However, if de-
fects occur despite our careful quality control, MICRO-EPSILON or your dealer must be notified immediately.
The liability for material defects is 12 months from delivery.
Within this period, defective parts, except for wearing parts, will be repaired or replaced free of charge, if the
device is returned to MICRO-EPSILON with shipping costs prepaid. Any damage that is caused by improper
handling, the use of force or by repairs or modifications by third parties is not covered by the liability for mate-
rial defects. Repairs are carried out exclusively by MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular,
MICRO-EPSILON shall not be liable for any consequential, special, indirect or incidental damage. In the inter-
est of further development, MICRO-EPSILON reserves the right to make design changes without notification.
For translations into other languages, the German version shall prevail.
10.
If the scanCONTROL 29xx is defective:
- If possible, save the current sensor settings in a parameter set,
- Please send us the effected parts for repair or exchange.
In the case of faults the cause of which is not clearly identifiable,
the whole measuring system must be sent back to:
11.
Incorrect disposal may cause harm to the environment.
scanCONTROL 29xx
Liability for Material Defects

Service, Repair

see Configuration Tools, menu Parameters > Save param-
eters to file..., in order to load the settings back again
into the sensor after the repair.

Decommissioning, Disposal

Remove all electrical connection cables between the scanCONTROL 29xx sensor and the downstream
control or evaluation units.
Dispose of the device, its components and accessories, as well as the packaging materials in compli-
ance with the applicable country-specific waste treatment and disposal regulations of the region of use.
MICRO-EPSILON Optronic GmbH
Lessingstraße 14
01465 Dresden - Langebrück /
Germany
Tel. +49 (0) 35201 / 729-0
Fax +49 (0) 35201 / 729-90
optronic@micro-epsilon.com
www.micro-epsilon.com
Page 59