Warnings/Error Signals - Otto Bock 1B1-2 Meridium Instructions For Use Manual

Appendices
Lot number
Article number
Please note the instructions for use
Check
Ottobock Data Station.
15.2 Operating states/error signals
The prosthesis indicates operating states and error messages through beeps and vibration signals.
15.2.1 Signals for operating states
Battery charger connected/disconnected
Beep signal
1x short
1x short
Mode switching
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see Page 26).
Beep signal Vibration sig­
nal
1 x short 1 x short
1 x short 1 x short
1 x short 1 x short
2 x short 2 x short
3 x short 3 x short

15.2.2 Warnings/error signals

Error during use
Beep signal
–
–
34
the product settings
Vibration signal
3x short
1x before beep signal
Additional action performed
Mode switching using the Cockpit
app
Tapping with
modes or
swing sideways three times to set
heel height
Weight placed on prosthetic leg
and leg kept still for 1 second to
switch mode or
feet placed on same level and
weight distributed evenly on both
feet to set heel height
Weight placed on prosthetic leg
and leg kept still for 1 second
Weight placed on prosthetic leg
and leg kept still for 1 second
Vibration signal
1 x long at interval of
approx. 5 seconds
3 x long
using the corresponding
Event
Battery charger is connected or
battery charger already disconnected prior to start of char­
ging mode
Charging mode started (3 sec. after connection of battery
charger)
Battery charger disconnected after start of charging mode
Event
Mode switching is performed using the
Cockpit app
heel to switch Motion pattern recognised
Switching to basic mode (mode 1) car­
ried out.
Switching to MyMode 1 (mode 2) car­
ried out.
Switching to MyMode 2 (mode 3) car­
ried out.
Event
Overheated hydraulic unit Reduce activity.
Battery charge
under 25%
adjustment software
Required action
level Charge battery soon.
1B1-2=* Meridium
of the