Scope Of Delivery And Accessories; Charging The Battery; Connecting The Power Supply And Battery Charger - Otto Bock 1B1-2 Meridium Instructions For Use Manual

5 Scope of Delivery and Accessories

5.1 Scope of delivery
• 1 pc. 1B1-2 Meridium
• 1 pc. 757L16-4 power supply
• 1 pc. 4E50-2 C-Leg battery charger
• 1 pc. 646C107 Bluetooth PIN card
• 1 pc. 647F542 prosthesis passport
• 1 pc. 647G1440=1 instructions for use (user)
• 1 pc. 647G1440=2 instructions for use (user)
• 1 pc. 647G1441 instructions for use (qualified personnel)
• 1 pc. 2C7 footshell inc. instructions for use
• 1 pc. 4G872=* set of cover caps
• 1 pc. 2C101 footshell replacement tool
Cockpit app for download
http://www.ottobock.com/cockpitapp
5.2 Accessories
The following components are not included in the scope of delivery and may be ordered separately:
• 60X5 BionicLink PC
• 1 pc. 757P48 Y adapter cable
This is for charging more than one product at the same time (e.g. 1B1-2; 1B1; 3B1/3B1=ST; 3B1-2/3B1-2=ST;
3B5-X3/3B5-X3=ST; 3C98-2/3C88-2; 3C98-3/3C88-3; 3C96-1/3C86-1) with the 757L16-4 power supply.
• 704G30 clamping tool

6 Charging the battery

The following points must be observed when charging the battery:
• Use the 757L16-4 power supply and 4E50-2 battery charger to charge the battery.
• The capacity of a fully charged battery is sufficient for one full day.
• We recommend charging the product once a day when used by the patient on a daily basis.
• For the maximum operating time with one battery charge, disconnecting the battery charger from the product
only immediately before using the product is recommended.
• The battery should be charged until the yellow LED on the battery charger turns off prior to initial use, and for
at least 4 hours. This calibrates the charge level indicator via the Cockpit app and by turning over the prosthes­
is.
If the battery charger is disconnected from the prosthesis too soon, the charge level indicator via the Cockpit
app and by turning over the prosthesis may not correspond to the actual charge level.
• The ankle joint of the prosthetic foot is locked during the charging process.
• The battery may discharge while the product is not being used.

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see fig. 1).
2) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery charger so that
the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
1B1-2=* Meridium
from the website:
2
Scope of Delivery and Accessories
• "Cockpit 4X441-IOS=V*" app for iOS
• "Cockpit 4X441-ANDR=V*" app for Android
3
13