Charging The Prosthesis Battery; Display Of The Current Charge Level - Otto Bock 1B1-2 Meridium Instructions For Use Manual

Charging the battery
3) Connect the round, three-pin plug of the power supply to the 12 V receptacle on the battery charger so that
the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger light up (see
fig. 3).
→ If the green LED on the power supply and the green LED on the battery charger do not light up, there is an
error (see Page 34).

6.2 Charging the prosthesis battery

6.3 Display of the current charge level

INFORMATION
The charge level cannot be displayed during the charging process.
Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see Page 26).
Display of the current charge level using the cockpit app:
Once the Cockpit app has been started, the current charge level is displayed in the bottom line of the screen:
14
1) Open the charging receptacle cover.
2) Connect the charging plug to the charging receptacle of the product.
INFORMATION: Take note of the plug direction!
→ The correct connection of the battery charger to the product is indicated by
feedback (see Page 36).
3) The charging process starts.
→ Once the product battery is fully charged, the yellow LED on the battery
charger turns off.
4) Disconnect the product after the charging process is complete.
→ This is followed by an electronics self-test which is confirmed by feedback
(see Page 36).
5) Close the charging receptacle cover.
1) Turn the prosthesis by 180° (the sole of the foot must face up).
2) Hold the prosthesis still and wait for beep signals.
Prosthetic foot with knee joint:
The beep signal for the knee joint sounds after approx. 2 seconds.
The beep signal for the prosthetic foot sounds after approx. 4 seconds.
Prosthetic foot without knee joint:
The beep signal for the prosthetic foot sounds after approx. 2 seconds.
Vibration signal
–
–
–
–
3x long
5x long
Battery charge level
More than 80%
66% to 80%
51% to 65%
36% to 50%
20% to 35%
Less than 20%
1B1-2=* Meridium