Gear Unit To Machine - Beckhoff AG3210 Operating Instructions Manual

Mechanical installation

Gear unit to machine

8.3
Output side
8.3.1
Permissible axial forces
8.3.1.1
52 ───
No washers necessary
Beckhoff recommends not using washers if the material of the
screw contact surface has an adequate interface pressure.
Avoid damage due to stresses
Use suitable tools for the assembly. Mount gear wheels and
toothed belt pulleys without force on the output shaft and avoid
mounting by driving or hammering on.
The gear unit can be damaged if stress occurs during mounting.
► Seal any gap over a wide area when attaching to the output side
► Make sure that the surfaces of the attached parts have a low
roughness
► Use only screw head seals and o-rings for sealing
The following table shows the maximum permissible static axial
forces:
Gear unit 005
Fa max [N] 1800
AG3210
015 025 035
4300 5100 11300
Version: 2.2
045
18500