Dimension drawing NP045
4.7.1
1-stage
Position
Explanation
K
Clamping hub diameter up to 38 mm
1)
Check motor shaft adaptation
2)
Smallest or largest permissible motor shaft length
3)
Dimensions are dependent on the motor
4)
Smaller motor shaft diameters are adaptable using a spacer sleeve with a minimum wall thick-
ness of 1 mm
Version: 2.2
• All figures in millimeters
• Dimensions without tolerance ± 1 mm
• Center bore according to DIN 332-DR M16x32
• Feather key according to DIN 6885-A 12x12x70
AG3210
Technical data
───
41