Related Manuals for Beckhoff AX2090-L80 Series
Summary of Contents for Beckhoff AX2090-L80 Series
- Page 1 Assembly instructions | EN AX2090-L80x Fan cover for synchronous servo motors AM8000 and AM8500 7/8/2020 | Version 1.0...
-
Page 3: Table Of Contents
Table of content T a b l e o f c o n t e n t Product overview.............................. 4 Fan cover ................................ 4 Name plate................................ 4 Technical data.............................. 5 Performance data of the external fan........................ 5 Scope of supply .............................. 6 Packaging ................................. -
Page 4: Product Overview
Product overview Fan cover The purpose of the fan cover is the external cooling of the motors. It therefore increases the performance data of the motor. This ordering option is available for motors of the following series: • AM8x5x and AM8x5x-xxxx-9000; flange compatible with AM3x5x •... -
Page 5: Technical Data
+24 V : Brown Not used GND: Blue Not used Documentation on the control cable ZK4054-6400-0xxx The data sheet of the control cable can be found under: www.beckhoff.com → Download → Data sheets → Cables and wires Version: 1.0 AX2090-L80x ───... -
Page 6: Scope Of Supply
Scope of supply Check missing or damaged parts Check your delivery for completeness. If any parts are missing or became damaged during transport, contact the carrier, vendor or our service department immediately. Check the shipment for the following contents: • Fan cover with fittings •... -
Page 7: Mechanical Installation
► Fit nuts [8] and [11] with washers [9] and [10] ► Observe tightening torques: Screws Nuts 3 Nm size 2.5 2.5 Nm, size 7 Use Beckhoff control cable Use the pre-assembled control cable ZK4054-6400-0xxx to connect the fan cover Version: 1.0 AX2090-L80x ───... - Page 8 Mechanical installation ► Plug the power connector [12] into the power box [13] of the mo- ► Hand-tighten power connector [12] and check for tight fit ─── AX2090-L80x Version: 1.0...
-
Page 9: Commissioning
Commissioning Commissioning example The procedure for commissioning is described as an example. A different method may be appropriate or necessary, depending on the application of the components. Before commissioning Pay attention to the following points before commissioning: • Check connection and function •... -
Page 10: Decommissioning
The trans- 6.1.1 port costs are borne by the sender. Send the used devices with the note "For disposal" to: Beckhoff Automation GmbH & Co. KG "Service" Building Stahlstrasse 31 D-33415 Verl In addition, you have the option to contact a local certified specialist company for the disposal of used electrical and electronic appli- ances. -
Page 11: Guidelines And Standards
EU conformity Provision Beckhoff Automation GmbH & Co KG will be pleased to provide you with EU declarations of conformity and manufacturer's declara- tions for all products on request. Please send your request to: info@beckhoff.com Version: 1.0... - Page 13 More Information: www.beckhoff.com/am8000 Beckhoff Automation GmbH & Co. KG Hülshorstweg 20 33415 Verl Germany Phone: +49 5246 9630 info@beckhoff.com www.beckhoff.com...