Beckhoff AG3210 Operating Instructions Manual page 51

1
1 2
5
Version: 2.2
Do not exceed the permissible axial forces
If the motor shaft cannot be inserted easily, the screw on the
clamping hub must be loosened a little more.
With certain motor shaft diameters, a slotted spacer sleeve must
be installed in addition. If there is a groove on the motor shaft, it
must be aligned with the slot in the spacer sleeve.
► Insert the motor shaft [1] into the clamping hub [2]
► Make sure that no gap is created between the motor and the
adapter plate
2
This example shows a motor size with four fixing points in the
3 4
flange.
► Apply threadlocker to bolts [1], [2], [3] and [4]
► Insert bolts [1], [2], [3] and [4] and tighten evenly to 90 % of the
yield strength of the bolts. Use bolts of strength class 8.8.
► Tighten bolt [5]. Refer to the chapter "Clamping hub", [Page 49].
► Insert the plug in the adapter plate again
Mechanical installation
AG3210 ─── 51