Adamson IS Series Rigging Manual page 39

4.0 Rigging Procedures
4.10 Suspending IS10s below IS119s
5. Affix the IS10 enclosure through the front tab
to the bottom front hole of the Rigging Frame
using the T45 Torx screws provided. A torque
setting of 6.5 Nm is to be used.
Adamson Systems Engineering | IS-Series Rigging Manual
6. To attach an IS10 rear to the Rigging Frame,
first remove the screws from the rear inner holes
of the Rigging Frame. Swing the rear rigging links
of the IS10 up and affix them to the top hole on
the frame through the "E" hole on the IS10 rigging
link.
Page 39