Adamson IS Series Rigging Manual page 28

4.0 Rigging Procedures
4.6 Ground Stacking IS10
8. With the rear rigging link still affixed to the
Rigging Frame, swing the rigging link (fig. 4) up
until the appropriate holes line up to achieve
the desired rigging position as per the Blueprint
design. Refer to the IS10 Ground Stacking
Rigging Frame Angle Chart below (fig. 6)
matching the appropriate Rigging Link Letter and
Rear Rigging Piece Number (fig. 5) to achieve
the desired angle. Make sure that both left and
right rear rigging positions are set to the identical
angle. Use a torque setting of 6.5 Nm.
IS10 Ground Stacking Rigging Frame Angle Chart
A B C
1 +0° -2° -4° -6°
2 +3° +1° -1° -3°
3 N/A +4° +2° 0°
* Tolerance of specified angles +/- 0.25°
Adamson Systems Engineering | IS-Series Rigging Manual
D
fig. 6
8
3
2
1
fig. 4 fig. 5
Page 28