Suspending Is7 Micro Frame - Adamson IS Series Rigging Manual

4.0 Rigging Procedures

4.2 Suspending IS7 Micro Frame

1. Remove the T25 Torx screws, and rear rigging
links from the IS7 being attached to the Micro
Frame.
2. With the T25 Torx screws removed earlier,
connect the rear of the IS7 Micro Frame to the
rear rigging pieces of the IS7, using X hole. A
torque setting of 6.5 Nm is to be used.
3. Remove the T25 Torx screws from the front
of the IS7 Micro Frame. Using these T25 screws,
connect the front of the IS7 Micro Frame to the
IS7 enclosure front tab. Use a torque setting of
6.5 Nm.
4. Connect additional IS7s as per steps 5 thru 8
of 4.1 Suspending IS7.
Adamson Systems Engineering | IS-Series Rigging Manual
Page 16