Adamson IS Series Rigging Manual page 29

4.0 Rigging Procedures
4.6 Ground Stacking IS10
9. To stack additional IS10s, position the next
IS10 above the stack already completed. Swing
the rear rigging links (fig. 4) still affixed to the
IS10 (hole X) until the appropriate holes line up to
achieve the desired rigging position. Refer to the
rigging legend displayed on each IS10 rear rigging
piece (fig. 5). The rigging positions listed on the
legend refer to the rigging position corresponding
to the design in Blueprint. Make sure that both
left and right rear rigging positions are set to the
identical angle.
10. For additional IS10s, repeat step 9.
Adamson Systems Engineering | IS-Series Rigging Manual
8
3
2
1
fig. 4 fig. 5
Page 29