Suspending Is10 Micro Frame - Adamson IS Series Rigging Manual

4.0 Rigging Procedures

4.5 Suspending IS10 Micro Frame

1. Remove the T45 Torx screws, and rear rigging
links from the IS10 being attached to the Micro
Frame.
2. With the T45 Torx screws removed earlier,
connect the rear of the IS10 Micro Frame to the
rear rigging pieces of the IS10, using X hole. A
torque setting of 6.5 Nm is to be used.
3. Remove the T45 Torx screws from the front of
the IS10 Micro Frame. Using these T45 screws,
connect the front of the IS10 Micro Frame to the
IS10 enclosure front tab. Use a torque setting of
6.5 Nm.
3. Connect additional IS10s as per steps 5 thru 8
of 4.4 Suspending IS10 to a maximum of 4.
Adamson Systems Engineering | IS-Series Rigging Manual
Page 24