Adamson IS Series Rigging Manual page 14

4.0 Rigging Procedures
4.1 Suspending IS7
4. To attach an IS7 rear to the Rigging Frame,
first remove the screws from the rear inner holes
of the Rigging Frame. Swing the rear rigging links
of the IS7 up and affix them to the top hole on the
frame through the "E" hole on the IS7 rigging link.
5. Position the next IS7 enclosure underneath the
assembled enclosure and frame. Remove the
T25 Torx screws from the bottom front holes of
the affixed IS7. Lower the frame until the upper
enclosure's bottom front hole (d) is in-line with the
front tab (b) of the second IS7 enclosure.
Adamson Systems Engineering | IS-Series Rigging Manual
d
b
Page 14