Adamson IS Series Rigging Manual page 22

4.0 Rigging Procedures
4.4 Suspending IS10
4. To attach the rear of an IS10 to the Rigging
Frame, simply use the rigging link that comes
attached to the Rigging Frame. Remove the T45
Torx screws and rigging links attached to the
IS10 rear rigging pieces, then affix the Rigging
Frame rigging link "X" hole to the "X" hole on the
IS10. Use the T45 Torx screws removed earlier
with a torque setting of 6.5 Nm.
5. Position the next IS10 enclosure underneath
the assembled enclosure and frame. Remove the
T45 Torx screws from the bottom front holes of
the affixed IS10. Lower the frame until the upper
enclosure's bottom front hole (d) is in-line with the
front tab (b) of the second IS10 enclosure.
Adamson Systems Engineering | IS-Series Rigging Manual
d
b
Page 22