Adamson IS Series Rigging Manual page 27

4.0 Rigging Procedures
4.6 Ground Stacking IS10
7. Remove the T45 Torx screws from the bottom
front holes of an IS10. Position the IS10 onto
the Rigging Frame. The bottom front corners of
the IS10 line up with the stacking links attached
to the Rigging Frame. Use the T45 Torx screws
removed earlier to connect the IS10 to the
Rigging Frame stacking links. A torque setting of
6.5 Nm is to be used.
Adamson Systems Engineering | IS-Series Rigging Manual
Page 27