Adamson IS Series Rigging Manual page 34

4.0 Rigging Procedures
4.8 Suspending IS7s below IS118s
5. Affix the IS7 enclosure through the front tab to
the bottom front hole of the frame using the T25
Torx screws provided. A torque setting of 6.5 Nm
is to be used.
7. For additional IS7s, follow Suspending IS7
steps 5 through 7 until the desired amount of
enclosures are affixed in the array.
Adamson Systems Engineering | IS-Series Rigging Manual
6. To attach an IS7 rear to the Rigging Frame,
first remove the screws from the rear inner holes
of the Rigging Frame. Swing the rear rigging links
of the IS7 up and affix them to the top hole on the
frame through the "E" hole on the IS7 rigging link.
Page 34