4.0 Rigging Procedures
4.4 Suspending IS10
1. Remove all links from the Rigging Frame by
removing the T45 Torx screws (a) affixing them
in place. Place the screws in a secure place for
future use.
2. Line up the IS10 enclosure front tab (b) so that
it will match to the bottom front hole (c) of the
Rigging Frame
3. Affix the IS10 enclosure through the front tab
to the bottom front hole of the Rigging Frame
using the T45 Torx screws (a) removed earlier. A
torque setting of 6.5 Nm is to be used.
Adamson Systems Engineering | IS-Series Rigging Manual
a
c
b
a
a
Page 21