Adamson IS Series Rigging Manual page 23

4.0 Rigging Procedures
4.4 Suspending IS10
6. Affix the front of the enclosures together with
the T45 Torx screws (a) removed earlier. A torque
setting of 6.5 Nm is to be used.
7. With the rear rigging link still affixed to the
second enclosure via the X hole, swing the rigging
link (fig. 4) up until the appropriate holes line up
to achieve the desired rigging position. Refer
to the rigging legend displayed on each IS10
rear rigging piece (fig. 5). The rigging positions
listed on the legend refer to the rigging position
corresponding to the design in Blueprint. Make
sure that both left and right rear rigging positions
are set to the identical angle.
8. Repeat steps 5 through 7 until the desired
amount of enclosures are affixed in the array.
Adamson Systems Engineering | IS-Series Rigging Manual
a
8
3
2
1
fig. 4 fig. 5
Page 23