Processor - Huawei FusionServer Pro 2288H V5 User Manual

FusionServer Pro 2288H V5 Server
User Guide
Table 2-5 LOM port description
Chip Model
X722
l Use
l The LOM ports support NC-SI, WOL, and PXE.
l The LOM ports do not support forced rates.
l The electrical LOM ports cannot be connected to power over Ethernet (PoE) devices
l The electrical LOM ports do not support SR-IOV.
l Forcibly powering off a server will cause intermittent NC-SI disconnection and disable

2.3 Processor

l
l
l
l
Issue 08 (2019-10-30)
Port Type
10GE optical
port
10GE electrical
port
GE electrical
port
Intelligent Computing Compatibility Checker
cables and optical modules supported by the LOM ports.
(such as a switch with PoE enabled). Connecting a LOM port to a PoE device may
cause link communication failure or even damage the NIC.
the Wake on LAN (WOL) function of the LOM ports. To restore the NC-SI connection,
refresh the iBMC WebUI.
The server supports one or two processors.
If only one processor is required, install it in socket CPU1.
The same model of processors must be used in a server.
Contact your local Huawei sales representative or use the
Compatibility Checker
Copyright © Huawei Technologies Co., Ltd.
Rate
Negotiation
Mode
Auto-
negotiation
10000 Mbit/s
(full duplex)
Auto-
negotiation
1000 Mbit/s
(full duplex)
Auto-
negotiation
10000 Mbit/s
(full duplex)
Auto-
negotiation
1000 Mbit/s
(full duplex)
to determine the components to be used.
2 Hardware Description
Supported Rates Not
Rate Supported
10000M 10/100/1000M
1000M 10/100M
10000M 10/100M
1000M 10/100M
to obtain information about the
Intelligent Computing
19