Processor - Huawei FusionServer Pro 2288H V5 Technical Manual

Huawei FusionServer Pro 2288H V5 Server
Technical White Paper
Chip Model
● Use
● The LOM ports support NC-SI, WOL, and PXE.
● The LOM ports do not support forced rates.
● The electrical LOM ports cannot be connected to power over Ethernet (PoE)
● The electrical LOM ports do not support SR-IOV.
● Forcibly powering off a server will cause intermittent NC-SI disconnection

5.3 Processor

●
●
●
●
Issue 12 (2020-04-20)
Port Type
GE electrical
port
Intelligent Computing Compatibility Checker
about the cables and optical modules supported by the LOM ports.
devices (such as a switch with PoE enabled). Connecting a LOM port to a PoE
device may cause link communication failure or even damage the NIC.
and disable the Wake on LAN (WOL) function of the LOM ports. To restore
the NC-SI connection, refresh the iBMC WebUI.
The server supports one or two processors.
If only one processor is required, install it in socket CPU1.
The same model of processors must be used in a server.
Contact your local Huawei sales representative or use the
Computing Compatibility Checker
Copyright © Huawei Technologies Co., Ltd.
Rate Supported
Negotiation Rate
Mode
Auto- 10000M
negotiation
10000 Mbit/s
(full duplex)
Auto- 1000M
negotiation
1000 Mbit/s
(full duplex)
to determine the components to be used.
5 Hardware Description
Rates Not
Supported
10/100M
10/100M
to obtain information
Intelligent
24