Table of Contents
Advertisement
FusionServer Pro 2288H V5 Server
User Guide
l
l
Issue 08 (2019-10-30)
If PSUs are properly installed but are not yet powered on, power on the PSUs.
The server will be powered on along with the PSUs.
By default, System State Upon Power Supply is set to Power On, which allows the server to
power on after the PSUs are applied with power. You can change the System State Upon Power
Supply on the Power > Power Control page on the iBMC WebUI.
If the PSUs are powered on and the server is in standby state (the power indicator is
steady yellow), you can use any of the following methods to power on the server:
– Press the power button on the front panel.
For details, see
2.1.2 Indicators and
– Use the iBMC WebUI.
i.
Log in to the iBMC WebUI.
For details, see
ii.
Choose Power > Power Control.
The Power Control page is displayed.
iii. Click Power On.
A confirmation message is displayed.
iv.
Click Yes.
– Use the iBMC CLI.
i.
Log in to the iBMC CLI.
For details, see
ii.
Run the following command:
ipmcset -d powerstate -v 1
iii. Type y or Y and press Enter.
– Use the Remote Virtual Console.
i.
Log in to the Remote Virtual Console.
For details, see
ii.
On the KVM screen, click
iii. Select Power On.
A dialog box is displayed.
iv.
Click Yes.
Copyright © Huawei Technologies Co., Ltd.
Buttons.
9.2 Logging In to the iBMC
9.4 Logging In to the
CLI.
9.3 Logging In to the Desktop of a
or
on the toolbar.
7 Installation and Configuration
WebUI.
Server.
99
Advertisement
Table of Contents
