Table of Contents
Advertisement
FusionServer Pro 2288H V5 Server
User Guide
1
3
5
7
9
Indicator Description
Table 2-3 Indicators on the rear panel
Indicator
PSU indicator
Issue 08 (2019-10-30)
Connection status indicator/
Data transmission status
indicator for a 10GE optical
port
Data transmission rate
indicator for a 10GE electrical
port
Data transmission status
indicator for a GE electrical
port
Data transmission status
indicator for the management
network port
UID indicator
Description
l Off: No power is supplied.
l Blinking green at 1 Hz:
– The input is normal, the server is in standby state, and
the PSU is in MV6 mode (output voltage is 6.7 V).
– The input is overvoltage or undervoltage.
– The PSU is in deep hibernation mode.
l Blinking green at 4 Hz: The firmware is being upgraded
online.
l Steady green: The power input and output are normal.
l Steady orange: The input is normal, but no power output is
supplied.
NOTE
The possible causes of no power output are as follows:
l Power supply overtemperature protection
l Power output overcurrent or short-circuit
l Output overvoltage
l Short-circuit protection
l Device failure (excluding failure of all devices)
Copyright © Huawei Technologies Co., Ltd.
2
Data transmission rate
indicator for a 10GE optical
port
4
Connection status indicator/
Data transmission status
indicator for a 10GE electrical
port
6
Connection status indicator
for a GE electrical port
8
Connection status indicator
for the management network
port
10
PSU indicator
2 Hardware Description
15
Advertisement
Table of Contents
