Siemens NXPLUS C Installation And Operating Instructions Manual page 273

Mounting the interlock
802-9081.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • Revision 11
Detail view
➭ Carefully thread the interlocking into the operating mechanism. Insert the lug ③ into the
driver at the top, and the tripping rocker ④ into the slide ⑤ .
➭ Fasten bolts ① and ⑦ (both M6x12 with hexalobular socket)
➭ Tighten the rocker ④ with the bolted joint ② .
➭ Fix the cables ⑥ again with 2 cable straps.
➭ Refit the front cover of the panel.
➭ Test proper functioning of the interlock according to the following table. All control
elements must be easy to operate.
Component
① Oil the bearing for the operating shaft.
① Apply grease to the guide of the closing
spring.
Precondition: Closing spring charged.
WARNING: Do not reach into the
operating mechanism compartment
with your hands when the operating
springs are charged.
Service information
Lubricants
Shell Tellus Oil S2M32
Isoflex Topas L32
① Bolt, left side
② Bolted joint
③ Lug
④
Tripping rocker
⑤ Slide
⑥ Cable strap (2x)
⑦ Bolt, right side
273/293