Siemens NXPLUS C Installation And Operating Instructions Manual page 136

Installation
136/293
Bolting material
Designation
Bolt-and-washer assembly
Setnut
Duct elements on the switchgear
For installation of the horizontal pressure relief duct on the switchgear, the following
elements are required. Here, the elements for a panel width of 600 mm are shown as an
example.
Designation
Side plate
Side plate
Rear wall
Rear wall
Top cover
Revision 11 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • 802-9081.9
Size
M8
M8
Detailed designation
Connecting element, lateral
evacuation, left side (with pre-
assembled evacuation duct
element)
Connecting element, lateral
evacuation, right side (with pre-
assembled evacuation duct
element)
Connecting element, rear
evacuation, (with pre-
assembled evacuation duct
element)
Rear wall, closed
Top cover with ventilation
Illustration
Illustration