Siemens NXPLUS C Installation And Operating Instructions Manual page 137

802-9081.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • Revision 11
Designation
Top cover
Front plate
Side plate
Side plate
Mounting the side plates
Before the horizontal pressure relief duct can be installed, the switchgear termination must be
mounted (see page 143, "Installing the switchgear termination").
Perform the installation from the front, starting with the left end panel.
Installation with lateral evacuation to the left is shown here as an example.
If a higher low-voltage compartment is mounted, it is not possible to install the horizontal
pressure relief duct from the front.
➭ Install from the top or from the side.
Or
➭ Remove the low-voltage compartment and install from the front.
Detailed designation
Top cover, closed
Front plate, closed
Side plate, closed, left side
Side plate, closed, right side
INFORMATION
Illustration
Installation
137/293