Error Messages - Leica 3D Disto User Manual

7
Error messages and
advice

Error Messages

Error Messages
Error No. Advice
150 Working range was exceeded.
151 Invalid measurement.
152 Change the 3D Disto position or use ruler for offset points.
153 Radius too small for chosen points! Increase radius.
160 Repeat and do not move the ruler between both measure-
ments.
161 In some cases the Offset Point tool can not be used.
170 Restart 3D Disto if the problem persists.
171 Check all devices, for example power supply or cables, and try
again.
240 Tilt sensor calibration was not successful. System accuracy is
at risk. Contact your distributor or Leica Geosystems repres-
entative.
241 Too much drift. Repeat calibration precisely.
243 Set up the instrument stably. Do not touch or rotate the 3D
Disto. Repeat calibration.
300 Select a horizontal line.
350 Check projection surface. Laser could not reach the correct
position.
755 Point cannot be measured. Try different position. Tool does
not work on horizontal planes.
760 Point cannot be measured. Enter different values. Tool does
not work on horizontal planes.
765 Point cannot be measured. Try different position or enter dif-
ferent value. Tool does not work on horizontal planes.
800 Data import or export is not possible.
801 Not enough memory on USB stick.
802 Storage device does not work properly.
803 Check file condition and content.
804 File or Folder write-protected or damaged.
900 3D Disto error. Contact your distributor or Leica Geosystems
representative if the error repeats.
901 The reflected laser signal is too low.
902 The reflected laser signal is too high.
903 Too much background light.
904 Laser beam interrupted. Repeat measurement.
950 Execute Location Check to retain accuracy!
951 3D Disto tilt is over 3°. Set up horizontally!
953 Check connection and cable.
954 Plug in cable or choose "WLAN" in the menu.
75