Leica 3D Disto User Manual page 68

Location Check step-
by-step
68
Step Description
3. If Secure Points are available, folder opens.
Choose a Secure Point by pressing
screen.
Press to enlarge.
Press to see all Secure Points of the whole memory.
4.
Press to confirm point.
Pointfinder opens.
5. Target the target mark shown in the photo as precisely as possible
and press
If successful, pop-up appears Measure next Secure Point? Yes/
Cancel.
6. If Yes: Folder opens to choose next Secure Point.
Proceed as described previously for the second and third
Secure Point.
If the first two Secure Points were measured successfully the 3D
☞
Disto roughly turns to the next chosen Secure Point. You just have
to do the fine targeting and press
7. When you have measured three points successfully a pow-up
shows OK. Measure more Secure Points? Yes/No/Cancel.
Press Yes to continue and proceed as described previously.
•
Press No to finish. If successful, a pop-up displays the dimen-
•
sions between old and new position: XXXm; Height: XXXm;
OK/Cancel. Accept with OK or Cancel to measure further
points.
If Relocation was not successful, pop-up prompts Out of toler-
ance! Measure more Secure Points? Yes/No/Cancel. Go on as
described previously.
8.
Press to close the application.
If the 3D Disto was unintentionally moved, for example got bumped, the geo-
metry of the measured points will no longer fit with that of the previously
measured points. Start a Location Check to sustain the current accuracy/
geometry.
to measure.
/ or by tapping on the
.
Software Applications