Leica 3D Disto User Manual page 67

Relocation step-by-
step
Software Applications
Step Description
3.
Target the Target marks as precisely as possible and press
measure.
3D Disto takes a photo and saves it with coordinates, labelled with
ID and date.
4. Pop-up prompts Measure more Secure Points? Yes/No.
5. Proceed as before and measure at least three Secure Points.
☞ You can add more Secure Points at any time.
Ensure you have enough well-measured Secure Points around your
☞
working area. Even if one is lost there must be at least three for a
successful relocation.
6. After saving a minimum of three points you may leave the applica-
tion by choosing No.
This feature allows the relocation of the 3D Disto into a defined coordinate
system previously established by the Secure Location procedure, for example
to complete a previous measurement.
Step Description
Use a 3D Disto position that allows targeting and measuring at
☞
least three Secure Points around your working area.
1. Press Menu » Applications » Location » Relocate.
2. A pop-up prompts you to define the tolerance.
Press OK to confirm the value.
A lower tolerance increases the accuracy of your measurements
☞
and requires precise aiming and visibility of the Secure Points.
If there are no Secure Points available but your measurement must
☞
fit to the geometry of a previous one, just start your measurement
with the same Base Line points. These are the first two points of a
measurement.
to
67