Leica 3D Disto User Manual page 65

Point projection
Software Applications
Step Description
☞ The grid can be moved up, down, left, and right on the screen in
small steps using
The perpendicular distance from a selected grid point to a refer-
ence line is displayed. Tap on this distance to enter a value.
Press to reset the grid position.
Press to align grid parallel to a selected line.
☞
Lines between design points can be drawn on the screen
if necessary before use of the Parallel tool.
Press to turn the grid by 90°.
Press to place the grid exactly on a reference point.
3.
Press to proceed.
Step Description
☞
Press to go back to the Aligner tool.
1. In layout mode, the Toolbar changes and you can start to project
the grid.
2.
Use the arrow keys to select a point and press
You can also select points by tapping on a point on the screen or
by using the remote control.
Porous, structured or rough surfaces cause problems if the laser
☞
beam cannot reflect off the exact position of the layout point.
/ / / .
.
65