Comfort Targeting - Leica 3D Disto User Manual

Comfort plumbing
step-by-step
6.5.2
Description

Comfort targeting

step-by-step
70
Step Description
1. Start application in Menu » Applications » Tool Kit.
The running application stays open in the background.
2.
Press on the Toolbar.
Pointfinder opens.
3.
Target and measure the point to be plumbed. Press
Pointfinder stays open.
4.
Roughly target expected plumb and press
If plumb is found the laser flashes to indicate the exact position.
5.
Press to close Tool Kit.
Comfort Targeting
Comfort Targeting allows laying out a point relative to a reference point on
vertical surfaces.
2.000 m
010906_001
Use this tool only on vertical surfaces. On tilted surfaces, the layout
☞
position will not be correct.
Step Description
1. Start application in Menu » Applications » Tool Kit.
The running application stays open in the background.
2.
Press on the toolbar.
Pointfinder opens.
3.
Target reference point on the wall. Press
4. Pop-up prompts to enter value for left or right distance to refer-
ence point. For left turn set a negative value. Enter 0 to lay out
points with only vertical offsets to the reference point.
Press OK to confirm the value.
Laser point flashes to indicate exact position.
5. Pop-up appears to enter vertical value (= distance above/below lay-
out point). Default value = 0.
Set a negative value for down turn. Press OK to confirm the value.
3D Disto turns and lays out the correct position. Laser point flashes
to indicate exact position.
0.500 m
Software Applications
.
.
.