Menu Map Key - YSI MultiDO 5400 User Manual

Menu Map Key

The following conventions are used in menu maps:
- Factory defaults are contained in ( ). If blank, no default value is loaded for
this menu. In certain menus, the user configuration will appear in ( ) once the
menu is configured.
- System range (if applicable) is in italics. "*" displayed after the range indicates
that the range is based on other system configuration i.e. set point submenus.
- (Not Available) indicates hardware is not installed or menu is not applicable
to system configuration.
The following graphics are used in menu maps:
- 
- Input is required at numeric or alpha/numeric keypad.
- - display of softkey indicates selection of softkey is required.
- q
- Make a selection from a pull down menu.
-
- Use three front panel key to proceed; (only used at adjust contrast
menu).
The menu map on the following page depicts how the menu map conventions and
graphics are used for configuring the DO alarm low value and enabling the DO
system alarms. (complete DO menu is not shown in example)
Menu Maps
YSI 5X00
226
MENU MAP EXAMPLE
Menu Maps
YSI 5X00
227