Key Pad; Connecting The Sensor And Cable - YSI Pro2030 User Manual

5. Place the battery cover on the back of the instrument and tighten the
four screws. Do not over-tighten.
Figure 1. Pro2030 with battery cover removed. Notice
battery symbols indicating polarities.
The waterproof instrument case is sealed at the factory and is not to
be opened, except by authorized service technicians. Do not attempt to
i
separate the two halves of the instrument case as this may damage the
instrument, break the waterproof seal, and will void the warranty.

Key Pad

2
1
Figure 2, Keypad
3
4
5
6
2
Number Key
1
Press and hold for 3 seconds to calibrate.
opens Calibrate menu from the Run screen.
2
Use to navigate through menus, to navigate
through box options along the bottom of the
Run screen and to increase numerical inputs.
3
Press once to turn instrument on. Press a
second time to turn backlight on. Press a
third time to turn backlight off. Press and
hold for 3 seconds to turn instrument off.
4
5
Press to confirm entries and selections.
6
Use to navigate through menus, to navigate
through box options at the bottom of the Run
screen and to decrease numerical inputs.

connectIng the sensor and caBle

"Bulkhead" refers to the single-pin connector at the end of the probe/cable
assembly where the dissolved oxygen (Do) sensor is installed (figure 3). The
conductivity and temperature sensors are located above and next to the bulkhead
respectively and are not user-replaceable.
When a dissolved oxygen sensor is not installed in the cable, the sensor
i
and cable's bulkhead connectors are not water-proof. Do not submerge
the cable without a sensor installed. Submerging the cable without a
sensor installed may cause permanent damage to the cable that is not
covered under warranty.
Description
Calibrate
Up Arrow
Power and Backlight
Menu
Use to enter the System Setup
menu from the Run screen.
Enter
Down Arrow
3