Version; Aquamanager And The System Menu - YSI MultiDO 5400 User Manual

Version

Menus → System →Version
The Version menu contains information about the 5X00 including: display and
control board firmware code version, firmware compile date and time, control board
temperature, AC and DC voltage and model number.
Notes:
- Firmware version information is required when contacting YSI support.
- The clock chip temperature range starts at 0oC. Values < 0oC are not valid
numbers.
- The normal operating range temperature will be a few degrees above ambient.
- AC powered units will run at a higher temperature than DC powered units.
- To view current AC and DC power values
and then return to menu. Power information does not refresh when version
menu is open.
Configuring the 5X00
to return to run screen
YSI 5X00
148

AquaManager and the System Menu

AquaManager users can configure most 5X00 system menus from a PC. After polling
the 5X00, use "Systems Management" from the node window to view and upload
5X00 configuration. System menus are configured at the Setup tab selections.
Notes:
- Always manually poll the 5X00 after uploading configuration changes and
verify uploaded information is retained. When configuration changes are
uploaded using AquaManager at the same time configuration changes are
being made by a user in the menus on a 5X00 instrument, the AquaManager
uploads may not be saved depending on the timing of keystrokes at the 5X00.
- The Run Screen must be displayed during normal operation. If the 5X00
is not at the run screen during AquaManager uploading, pressing
the 5X00 will only save certain configuration changes.
See Chapter 5 AquaManager - page 197 and AquaManager online help for ad-
ditional information.
Configuring the 5X00
YSI 5X00
149
at